HOW TO MAKE FROSTING FOR CAKE POPS RECIPES

Steps:

• Preheat oven to 350 degrees F (175 degrees C). Grease a 9x13-inch baking dish.
• Beat cake mix, water, eggs, and oil in a bowl using an electric mixer on low speed for 30 seconds. Increase speed to medium and beat for 2 minutes more. Pour batter into the prepared baking dish.
• Bake in the preheated oven until a toothpick inserted in the center comes out clean, 28 to 33 minutes. Cool completely, at least 1 hour.
• Crumble cake into a large bowl. Stir frosting into cake crumbles until mixture is sticky but not too smooth. Chill in refrigerator, at least 30 minutes.
• Roll cake mixture into 1 1/2-inch balls and arrange on a baking sheet. Place 1 lollipop stick into each ball.
• Melt about 1/4 cup chocolate candy melts in a microwave-safe bowl in the microwave, about 20 seconds. Dip each cake pop in the melted chocolate. Repeat melting chocolate and dipping remaining cake pops. Decorate pops with decorating icing.

Steps:

• Prepare and bake the cake according to the package directions for a 9-by-13-inch pan. Let cool completely.
• Break the cake into pieces and place it in a food processor. Add the frosting and process until the mixture forms a ball and pulls away from the sides of the bowl, about 30 seconds. If the mixture doesn't come together, add more frosting 1 tablespoon at a time until it holds its shape.  
• Using a 3/4-ounce scoop, form the mixture into 46 balls and put them on a baking sheet. Refrigerate until firm, about 30 minutes. 
• Meanwhile, place the candy wafers in a microwave-safe bowl and melt according to package directions. Dip a half inch of the tip of a lollipop stick into the candy and then stick the tip halfway into a cake ball. Repeat with the remaining balls and sticks. Refrigerate the cake pops until completely chilled, about 1 hour.  
• Microwave the candy again until melted and pour it into a tall narrow glass. Dip each cake pop into the candy and let any excess run off. If decorating, turn the cake pop upright and sprinkle with sprinkles while the coating is still wet. Stick the finished pops in two 9.8-by-11.8-inch Styrofoam blocks block and let set completely.