TOMATO SOUP USING CANNED TOMATOES RECIPES

Steps:

• Set up an ice water bath: large bowl, lots of ice, a little water
• Place a strainer or colander in sink and bring a pot of water to a boil, 4 inches deep
• Using a paring knife, remove the core from the top of each tomato and score the bottom of the skin of the tomato with an X
• When water boils, gently place tomatoes in water and let them roll around 1 full minute
• Transfer the tomatoes to the ice bath using a spider or tongs
• Cool and peel tomatoes, letting them drain a bit as you work in the strainer
• Slice and chop the tomatoes and place in a bowl
• Heat a soup pot over low heat with 2 tablespoons EVOO, 2 turns of the pan
• Add the butter, and when it melts into oil, add Vidalia onions and season with salt and pepper
• Do not let the onions brown
• Let them sweat 10 to 15 minutes and add 1 cup water to onions, raise heat to medium-high, and let the water absorb and cook the onions to absolute mush
• Add tomatoes, basil and stock and cook at medium boil 20 minutes to break down tomatoes
• Remove basil stem and puree the soup using an immersion blender or transfer to food processor or high-power blender and puree, then return to pot
• Simmer gently over lowest heat until ready to serve
• Top with a few small leaves of torn basil

Steps:

• Melt butter over medium heat in a Dutch oven or large saucepan.
• Add onion wedges, water, can of tomatoes with their juices, and 1/2 teaspoon of salt. Bring to a simmer. Cook, uncovered, for about 40 minutes. Stir occasionally and add additional salt as needed.
• Blend the soup, and then season to taste. The soup doesn’t need to be ultra-smooth, some texture is a nice touch. An immersion blender does make quick work of this, or you can use a blender. If you use a regular blender, it is best to blend in batches and not fill the blender as much as you usually would since the soup is so hot. We like to remove the center insert of the lid and cover it with a kitchen towel while blending — this helps to release some of the steam and prevents the blender lid from popping off (which can be a big, hot mess).