MAKE YOUR OWN CHEESE RECIPES

Steps:

• Warm the milk to 200°F: Pour the milk into a 4-quart pot and set it over medium heat. Let it warm gradually to 200°F, monitoring the temperature with an instant read thermometer. The milk will get foamy and start to steam; remove it from heat if it starts to boil.
• Add the lemon juice and salt: Remove the milk from heat. Pour in the lemon juice or vinegar (or citric acid) and the salt. Stir gently to combine.
• Let the milk sit for 10 minutes: Let the pot of milk sit undisturbed for 10 minutes. After this time, the milk should have separated into clumps of milky white curds and thin, watery, yellow-colored whey — dip your slotted spoon into the mix to check. If you still see a lot of un-separated milk, add another tablespoon of lemon juice or vinegar and wait a few more minutes.
• Strain the curds: Set a strainer over a bowl and line the strainer with cheese cloth. Scoop the big curds out of the pot with a slotted spoon and transfer them to the strainer. Pour the remaining curds and the whey through the strainer. (Removing the big curds first helps keep them from splashing and making a mess as you pour.)
• Drain the curds for 10 to 60 minutes: Let the ricotta drain for 10 to 60 minutes, depending on how wet or dry you prefer your ricotta. If the ricotta becomes too dry, you can also stir some of the whey back in before using or storing it.
• Use or store the ricotta: Fresh ricotta can be used right away or refrigerated in an airtight container for up to a week.

Steps:

• In a large pot, heat the milk to 85°F, stirring frequently.
• As the milk is heating, add the calcium chloride, if using.
• When the milk gets to 85°F, add culture, stir in with an up-and-down motion, cover, and ferment for 1 hour. (Note: It does not have to stay at 85. If it naturally drops in temperature, that is OK.)
• Stir to homogenize the milk, and slowly fold in the diluted rennet. Using an up-and-down motion with your spoon will ensure that the rennet works its way through all the milk, so you can get the highest possible yield.
• Remove from heat source and allow the cheese to set for 1 hour, or until the whey begins to separate from the curd. You should see a layer of mostly clear whey floating on top of the curd, and the curd should be pulling away from the sides of the pot.
• Using the knife, carefully cut the curds into ¼-inch cubes and allow to set for 5 minutes. Do not stir.
• Over the next 30 minutes, slowly heat the curds to 100°F, stirring frequently. As you stir, the curds will shrink.
• Once the curds are at 100°F, maintain the temperature and continue stirring for the next 30 minutes. If the curds get too hot, remove from heat.
• After 30 minutes, stop stirring and allow the curds to settle to the bottom of the pot. This will take about 20 minutes.
• Pour the curds into a colander. Place the colander and curds back into the cheese pot and allow to drain for 15 minutes.
• Remove the colander from the pot and turn the curds out onto a cutting board. You should have a semi-solid mass that looks like jelly. Pour the whey out of the pot, cut the mass into five slices, and place back into the pot. Cover.
• Fill a sink or basin with 102°F water and place the pot and curds into it. Keeping the temperature of the curds right around 100°F, turn the slices every 15 minutes for the next 2 hours. This is the cheddaring process and will give your cheese its unique flavor and deliciousness.
• After 2 hours, the curds will be shiny and very firm. Remove them from the pot and cut into ½-inch cubes. Place back in the pot, cover, and place in the sink filled with 102°F water.
• In 10 minutes, stir gently with your fingers or a wooden spoon. Repeat twice more.
• Remove the pot from the sink and add salt. Stir gently once more.
• Line the cheese press with a piece of cheesecloth and carefully place the curds into the press. Wrap the cloth around the cheese andpress at 10 pounds of pressure for 15 minutes.
• Remove the cheese from the press, unwrap, and flip the cheese. Re-wrap using a fresh piece of cheesecloth, and press at 40 pounds of pressure for 12 hours.
• Remove the cheese from the press, unwrap, and flip the cheese. Re-wrap using a fresh piece of cheesecloth, and press at 50 pounds of pressure for 24 hours.
• Remove the cheese from the press and air-dry for 2 to 3 days, until smooth and dry to the touch.
• Wax the cheese and age at 55° to 60°F for at least 60 days. (Click here for practical methods for aging cheese.)