HOW TO MAKE BARBECUE PORK RIBS RECIPES

Steps:

• 1. Preheat the oven to 200ºC/gas 6. Preheat your barbecue.
  2. Drizzle a little oil over the ribs, season with sea salt and black pepper and rub all over to coat.
  3. Make the marinade. Deseed and finely chop the chilli, peel and grate the ginger and garlic then place them all in a medium pan along with the apple juice, white wine vinegar, tomato ketchup, mustard, soy sauce and brown sugar.
  4. Whisk the ingredients together and place the pan over a medium heat. Stir until the sugar dissolves, then simmer for 10 to 15 minutes, or until the sauce has thickened.
  5. Put the ribs in a large roasting pan, brush with the marinade and cover with foil.
  6. Cook in the oven for 1 hour 15 minutes, or until the meat pulls away from the bone easily. Baste the ribs with the marinade after 30 minutes. After 1 hour of cooking time remove the foil, baste and cook, uncovered, for the final 15 minutes, basting halfway through.
  7. Once your barbecue is hot, transfer the ribs to it. Cook over a medium-low heat for 5 to 10 minutes.
  8. Transfer the ribs to a board and cut them up. Serve with handfuls of rocket and watercress, if you like.

Steps:

• Set a smoker to 225 degrees F.
• Combine the paprika, black peppercorns, coriander seeds, cumin seeds, garlic powder, onion powder, nutmeg and cayenne in a spice grinder. Process until a fine powder is formed, approximately 30 seconds.
• Pat the ribs dry and turn bone-side up. Trim excess fat and, if one end of the ribs is especially narrow, trim meat and bone to ensure even cooking. Remove the membrane on the underside of the ribs by inserting a rounded utensil, an upside-down spoon works well, between the membrane and the meat at one end of the slab. Carefully work the spoon under the membrane to loosen but not tear. Once enough has been loosened, use a paper towel to hold onto the membrane as you slowly pull it down the slab to remove.
• Sprinkle the ribs on both sides with the salt and brush both sides with the mustard. Sprinkle two-thirds of the spice mixture on the meat side of the ribs and the remaining third on the bone side.
• Once the smoker has reached 225 degrees F, add the wood chips or chunks and the ribs to the smoker.
• Smoke for 4 to 5 hours then test for doneness. There are four criteria that should be met in order for ribs to be done. First, the internal temperature of the meat should be 185 to 190 degrees F. Second, pick up each slab from the center with tongs and it should droop into a u-shape and crack slightly. Third, while holding with the tongs, and bouncing gently, the surface of the ribs should crack slightly. Lastly, the meat should pull easily off the bone but not fall off. If ribs pass all tests, remove them from the smoker and wrap in heavy-duty foil and rest for 15 minutes. If not, continue smoking for 45 minutes to 1 hour and test again until done.