ROAST BEEF WRAP IDEAS RECIPES

Steps:

• Remove the roast from refrigerator 1 hour before cooking to reach room temperature. Trim all the fat off the meat. Using a sharp knife, pierce meat about 1/2-inch deep and insert slivers of garlic in each hole, pushing all the way in. Lightly spray the meat with olive oil and season generously with salt, pepper and rosemary. Place the thermometer all the way into the center of the meat.
• Preheat oven to 350F. When the oven reaches 350F, place the roast in a roasting pan and put in the oven.
• Roast until the thermometer reads 130° for rare, 140° for medium rare, 150° for medium, and 155-160° for well done. Remove the roast from the oven and let it rest 10-20 minutes before you cut it so that the juices distributed evenly. I personally remove my roast beef from the oven when it is 135° for medium rare. The temperature will rise an additional 5 degrees as it sits.
• Slice thin and serve.

Steps:

• Preheat the oven to 450 degrees F. Line a 9-by 13- by 2-inch pan or your oven's broiler pan with a sheet of heavy-duty aluminum foil large enough to fully wrap the roast. The shiny side of the foil should be up. Sprinkle the roast on all sides with salt and pepper and place it in the center of the foil. Spread the onion slices over the top of the roast and pour the vinegar around it. Bring the ends of the foil together and fold several times, and then fold the ends together to completely enclose the roast. Pour about 1 inch of water into the pan around the foil-wrapped roast. Bake until the meat is fork tender and brown, 3 to 4 hours. Check the water level in the pan regularly during cooking and replenish it if necessary. If any juice seeps from the foil seals during roasting, save it to use in making the gravy. When the roast is done, remove the package from the baking pan and let it cool for a few minutes. Open the package carefully to preserve all the juices and transfer the meat to a platter. Cover with a tent of foil to keep it warm while you make the gravy. Pour the roasting juices into a measuring cup and let the fat rise to the surface. Skim off the fat, reserving 4 tablespoons in a saucepan and discarding the rest. (If the fat measures less than 4 tablespoons, add enough butter to make up the difference.) Measure the remaining defatted pan juices and reserve. If you have less than 2 cups, add water to make 2 cups. Add the flour to the fat in the saucepan and stir with a wire whisk to make a roux. Cook over medium-low heat until the flour is lightly browned, about 1 minute. Slowly whisk in the reserved pan juices and stir until thickened. Slice the roast or cut it into chunks (it will be very tender), and serve it with the gravy.