OIL INFUSED RECIPES

Steps:

• Follow the Basic LEVO Coconut Oil Infusion recipe to get a head start by using your LEVO machine to infuse cannabinoid rich flower with coconut oil.
• This recipe requires 1/4 cup of the infused coconut oil.
• Before beginning, prep your work space and your gummy molds. Set your gummy molds on a cookie sheet (for sturdy transport) and spray them with a non-stick cooking spray. I used coconut oil spray, which will harden & absorb (and not leave a wet & oily coating over the gummies like canola oil spray did). I also combined the 4 gelatin packets into a small bowl and opened the flavored gelatin ahead of time and set them near the stove for quicker and easier mixing. Set your syringes/dispensers and whisk within reach, too.
• In a small saucepan, bring the water, infused coconut oil, and lecithin to medium heat and whisk together until fully combined (see photo below). Once the mixture starts to bubble, increase to medium-high heat for a rolling boil. Slowly add in the unflavored gelatin while continuously whisking at the same time. Do not stop whisking!!! Once the unflavored gelatin is mixed in, add in all of the flavored gelatin while continuing to whisk. Whisk together on medium-high heat for about 1 minute until fully combined and smooth.
• Turn down heat source to low heat while continuing to whisk. Mixture should still be bubbling, but not boiling. Working very quickly, begin to fill your molds. Stir the mixture every so often to recombine. Mixture will continually get thicker and thicker as the gelatin sets, so you only have a few minutes to fill the molds.
• Once the mixture is used up, place the molds in the freezer or refrigerator for the gummies to harden, about 20 minutes to an hour. Once completely set, pop them out of the molds and store in an air-tight container in the refrigerator until ready to enjoy.
• Share what you make with @LEVO_Oil and be sure to tag it with #LEVOmade.

Steps:

• Grind up the cannabis. Preferably grind up the flower/bud as it’s the most potent and will get you a more accurate measurement, but you can include the whole plant. Make sure that it is large enough to not fall through the cloth/strainer. Anything fine enough will end up in the final product.
• Decarboxylate your cannabis by spreading the cannabis evenly on a baking tray and putting it in the oven for 45 minutes at 240 degrees Fahrenheit. (If you are using trichomes/kief scroll down to image at bottom)
• With the cheesecloth wrap the ground cannabis and tie it together.
• Add oil and cannabis into either a slow cooker, double-boiler, or saucepan. For a slow cooker cook on low for 4-6 hours, and stirring it occasionally. Using a double-boiler, cook on low for 6-8 hours ( 8 hours is recommended), and stirring occasionally. Finally using a saucepan, cook on low for 3 hours and stir it frequently, as the saucepan is susceptible to scorching..Tip* You can add a bit of water to the mixture to help prevent burning.Note: The temperature of the oil should not exceed 240 F no matter which method is used.
• Strain and capture the oil. If using a cheesecloth do not squeeze, this adds more unnecessary chlorophyll to the oil. Leftover plant materials can be discarded.
• Finished ! The oils shelf life is at least 2 months! And can be extended by keeping it refrigerated.