LORANN HARD CANDY RECIPE SMALL BATCH RECIPES

Steps:

• 1. In a heavy (good quality) 2-quart saucepan, mix together sugar, corn syrup and water. Stir over medium heat until sugar dissolves.
• 2. Insert candy thermometer if using, making certain it does not touch the bottom of the pan. Bring mixture to a boil without stirring.
• 3. Early in the cooking process, 'wash down' any sugar crystals that form on the sides of the pan with a wet pastry brush.
• 4. Continue to cook the syrup, without stirring, until the temperature reaches 260F; add drops of coloring until desired hue is achieved. Do not stir; boiling action will incorporate color into syrup.
• 5. Remove from heat precisely at 300F (temperature will continue rising), or until drops of syrup form hard, brittle threads in cold water (hard crack stage). After boiling action has ceased, add flavor and stir. USE CAUTION WHEN ADDING FLAVORING TO AVOID RISING STEAM.
• 6. Carefully pour syrup into prepared molds or onto the prepared greased and foil lined cookie sheet. (As the sugar mixture begins to set up, you may want to score with a large knife to mark squares.) Do not refrigerate.
• 7. Cool completely. Break sheet candy into small pieces and dust with powdered sugar, if desired. Store in airtight containers between waxed paper. If making lollipops, do not dust with powdered sugar, but place in sucker bags and secure with twist ties. Store hard candy in a cool, dry place. Do not refrigerate.

Steps:

• Combine Jell-O, unflavored gelatin and citric acid in a medium microwave-safe bowl and stir to combine.
• Add the corn syrup and water, and stir gently with a soup spoon until all of the ingredients are blended together. Stirring too fast may add air bubbles to the mixture, so keep it slow and sweeping. Let the mixture sit for 5 minutes so that the gelatin can bloom.
• Stir the candy syrup gently again, then microwave it on high for 30 seconds. Stir it again, then zap it for another 15 seconds. Repeat heating it for 15 seconds 3 more times for a total heating time of 1 1/2 minutes. If air bubbles begin to form on the surface of the gelatin, stop heating and stir gently. You don't want any bubbles in the syrup if you can help it. Let the mixture sit for 10 minutes. Give the solution a gentle stir every couple of minutes and you should see it become clearer over time.
• Spray the bear molds lightly with oil spray.
• Pour the candy syrup into a measuring cup with a spout, then carefully pour the liquid into the bear molds. Don't fill each bear all of the way to the top. Leave a little room in each mold.
• Let the candy sit for 30 minutes, then put the molds into your refrigerator for another 30 minutes.
• When the candy is firm push each piece out of the molds and arrange them on a baking sheet or in a large storage container so that they are each standing upright. Let them sit this way for 48 hours, then lay them on their backs for 24 hours. This process will help the bears dehydrate so that they are chewy like the originals. Depending on your climate, your gummy bears may have shrunken enough after 72 hours. If not, leave them out for another day or two, until they are chewy. Toss them around every so often as they dry out. When they are chewy enough for you, seal them up in an air-tight covered container or zip-top bag. Keep them stored in a sealed container and they should last for a couple weeks.