HOW TO CAN POTATOES WITH A PRESSURE COOKER RECIPES

Steps:

• Set the Quick Cooker to SEAR and press START. Heat the oil for 3 minutes. Season both sides of roast with the oregano, thyme, salt, and pepper. Add the roast to the Quick Cooker and cook uncovered for 10 minutes, turning halfway through.* Remove the roast and set aside. Press CANCEL.Add the onion and cook uncovered for 4 minutes, stirring occasionally.* Place the carrots, broth, and roast on top of the onion. Place the wire rack over the roast with all three feet touching the bottom.**For the potatoes, place the potatoes, broth, and garlic in the Ceramic Pot and cover with the stretch-fit lid. Place the ceramic pot into the wire cradle and lower onto the wire rack. Lock the lid, select the BEEF/PORK setting, and press START.When the timer is up, let the steam release naturally for 10 minutes, then press the steam-release button to release any remaining pressure. Carefully lift the ceramic pot out.† Mash the potatoes. Add the butter and salt, and mix thoroughly. Press CANCEL.Transfer the roast to a cutting board, slice it, and serve with the vegetables, mashed potatoes, and pan sauce.*

Steps:

• Place two large pots of water on the stove and bring them to a boil.  One is to pre-cook the potatoes, and the other is fresh, clean water that will be used as canning liquid in the jars.  Important: Do not re-use cooking liquid from the potatoes for packing.
• While the water is coming to a boil, prepare your potatoes.  Peel the potatoes, and chop any large spuds into 1 to 2'' pieces.  Smaller potatoes under 2'' in diameter can be left whole, but still must be peeled.  Place the potatoes in a bowl of water and keep them submerged to prevent browning while you work. 
• Once the water is boiling, place the potatoes into the water and pre-cook for 2 minutes (for 1'' cubes) or 10 minutes (for whole potatoes about 2'' in diameter).  Strain the potatoes after cooking and discard the cooking liquid.
• Pack the cooked potatoes into canning jars (pints or quarts, quarts recommended for efficiency). Leave 1'' headspace. 
• Cover with clean, boiling water and add 1 tsp salt per quart (optional). 
• Wipe rims and apply 2 part canning lids, tightening to just finger tight. 
• Place your pressure canner on the stove and add about 2'' of boiling water to the bottom from the clean boiling water pot.  Insert the canning rack that came with the canner, and then load in the hot jars into the pressure canner.  
• Close the pressure canner and allow the steam to vent for 10 minutes before fully sealing with a canning weight.
• Allow the pressure canner to come up to pressure, and begin timing once the required pressure is shown on the gauge.  When canning potatoes under 1000 feet in elevation, set the pressure canner to 10 pounds pressure and process for 35 minutes (pints) or 40 minutes (quarts).  For other altitudes and when using a dial gauge pressure canner, see the table above for the appropriate times/pressures for canning potatoes.